Table of Contents
Advertisement
3. BACK PANEL
An example TCG 01-G back panel is shown in Figure 5 below. Its appearance may vary, as different
connector types can be fitted at the factory to suit your requirements.
Figure 5 Rear panel of TCG 01-G, configured with 2-pin connectors (P2 and P3)
P1: Power Input (2-pin Connector [5.08 mm])
Power is applied to the unit via this plug. Maximum steady state power consumption is
6 W, and surge protection is provided. A mating connector is supplied that is suitable
for wiring up to 1.5 mm
Note that the DC input is protected against incorrect power supply polarity .
The power supply inputs are isolated from earth so that any earthing system is
acceptable (PEN, positive earth, negative earth or non-earthed low voltage
supply).
Check the label on the unit base for power supply voltage rating!
Earth Stud (M4 Nut)
Located under the serial port, to the left of the P4 designator is a M4 bolt provided
for earthing. An external ground connection must be connected to ensure
appropriate grounding for the unit.
TEK-TCG 01-G-Manual-v5-092016
© 2016 by Tekron International Limited. All Rights Reserved. All trademarks are the property of their respective holders. The
information in this document is provided for informational use only and is subject to change. For further information or support, go to
www.tekron.com.
2
.
P a g e
| 10
www.tekron.com
Advertisement
Table of Contents
