Table of Contents
Advertisement
Electrical
Electrical Specification
CMOS/TTL (5 V) logic level driver output ports, 150 mA sink and
TTL
source. The port is fully floating and has independent electrical
isolation to 2.5 kV.
High Speed RS422/485 (5 V differential) output ports. The port is
RS422
fully floating and has independent electrical isolation rated to 2.5 kV.
Power MOSFET Switch, allowing switching of 300 VA, 1 A max. The
port is fully floating and had independent electrical isolation rated to
HV MOSFET
2.5 kV. Refer to Figure 11 for suggested wiring configurations for use
with Power MOSFET switching.
ST fiber transmitters, compatible with ST-terminated 62.5 μm fiber
diameter, 125 μm jacket diameter multi-mode fiber optic cabling.
Fiber
The maximum length of fiber recommended is 750 m.(λ=820 nm)
Examples of the three connector types are given in (Figure 6) to (Figure 8);
Figure 6 2-pin connector
P2, P3 Programmable Output Options
The user may configure P2 and P3 to output in either inverted or non-inverted polarity:
A configurable number of pulses per second, minute, hour, day with adjustable pulse-width
and offset.
IRIG-B and DCF-77 time codes.
TEK-TCG 01-G-Manual-v5-092016
© 2016 by Tekron International Limited. All Rights Reserved. All trademarks are the property of their respective holders. The
information in this document is provided for informational use only and is subject to change. For further information or support, go to
www.tekron.com.
Figure 7 BNC connector
P a g e
| 12
Physical
2-pin
or BNC
2-pin
2-pin
ST Fiber
Figure 8 Fiber connector
www.tekron.com
Advertisement
Table of Contents
