Advertisement
Before You Begin
This product is intended to be installed by trained
service professionals
This manual explains the procedures for installing the
ecobee Smart Thermostat. Please read it carefully
before
beginning the installation.
For information on how to operate the ecobee Smart
Thermostat, please see the ecobee User's Manual.
The ecobee Smart Thermostat consists of two parts
(see images below):
1. A Smart Thermostat to be mounted on the
homeowner's wall.
2. An Equipment Interface Module This should be
mounted in the homeowner's utility room and
connects to the heating, cooling and ventilation
equipment.
Caution: Disconnect electric power to the system
before installing this product. Failure to do so could
result in electric shock and/or equipment damage.
All wiring must conform to your local electrical code.
Mercury Notice: This product does not contain
mercury.
If you are replacing a product that does contain
mercury please contact your local waste-management
authority for disposal instructions. Do not discard the
old product in the regular trash.
HVAC System Compatibility information
ecobee is designed to operate low-voltage heating
and cooling systems. It is not designed for use with
line voltage or millivolt heating and cooling systems.
Ecobee supports control of up to four heating stages
and two cooling stages. It also supports control of
humidifiers, dehumidifiers, heat-recovery ventilators
and energy-recovery ventilators.
Equipment Description
Gas/Oil/Electric heating (up to three stages) Yes
Heat pump with auxiliary heat (up to four stages) Yes
Geothermal Heat Pump Yes
Duel fuel systems Yes
Standard electric cooling (up to two stages) Yes
Boilers Yes
Central humidifier Yes
Central dehumidifier Yes
Heat Recovery Ventilator (HRV) Yes
Energy Recovery Ventilator (ERV) Yes
Sensors with dry contact outputs Yes
Toll Free 1.877.932.6233, Int. 1.647.428.2220,
| 250 University Ave | Suite 400 | Toronto, Ontario | M5H 3E5
Approvals
This product was designed and built in accordance to
RoHS directive 2002/95/EC and contains no
hazardous substances as defined by this directive.
Optional Power supply meets EPA C.E.C Level IV
and E.C CoC No Load power Consumption
requirements. It is also safety approved to UL/cUL
standards.
FCC Compliance Statement
This equipment has been tested and found to comply
with the limits for Class B digital devices, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
Encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment
and receiver Connect the equipment to an outlet on a
different circuit from the receiver Consult the dealer or
an experienced radio/TV contractor for help.
Warning: Changes or modifications not expressly
approved by ecobee Inc. could void the user's
authority to operate the equipment.
To satisfy FCC/IC RF exposure safety requirements,
a separation distance of 20 cm or more should be
maintained between this device and persons. To
ensure compliance, operation at closer than this
distance is not allowed.
support@ecobee.com
Advertisement
