Using This Unit With A Pioneer Plasma; Display; Using The Sr+ Mode With A Pioneer Plasma Display - Pioneer S-DV9 Operating Instructions Manual

Connecting up
Using this unit with a Pioneer
plasma display
If you have a Pioneer plasma display (models
PDP-504HDG and PDP-434HDG), you can use
an SR+ cable (see note below) to connect it to
this unit and take advantage of various
convenient features, such as automatic video
input switching of the plasma display when the
input is changed.
Pioneer plasma display
Media receiver
• Use a 3-ringed miniplug SR+ cable to
connect the CONTROL IN jack of this unit
through a media receiver to the CONTROL
OUT jack of your plasma display.
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ control options for Pioneer plasma displays
on page 66 for detailed instructions.
CONTROL
OUT
VIDEO
IN
OUT
P
R
CONTROL
COMPONENT
VIDEO OUT
S-VIDEO
OUT
P Y
B
VIDEO
SPEAKERS
Using the SR+ mode with a Pioneer
plasma display
When connected using an SR+ cable, a
number of features (such as automatic video
input switching and volume muting on the
plasma display) become available to make
using this unit with your Pioneer plasma
display even easier.
See also SR+ control options for Pioneer
plasma displays on page 66 for information on
setting up the unit.
1 Make sure that the plasma display and
this unit are switched on and that they are
connected with an SR+ cable.
See Using this unit with a Pioneer plasma
display above for more on connecting these
components.
2 To switch SR+ mode on/off, press SR+
(SHIFT + 7).
The front panel display shows the new setting;
SR+ ON or SR+ OFF.
• If SR+ Error shows in the display, it means
there is a communication problem
between the unit and the plasma display.
Check all connections and retry.
• The 3-ringed SR+ cable from Pioneer is
commercially available under the part
number ADE7095. Contact the Pioneer
Customer Support division for more
information on obtaining an SR+ cable.
• You won't be able to use the remote sensor
of this unit with the CONTROL IN jack of
this unit connected to the CONTROL OUT
jack of your plasma display. You can use
the remote sensor of the plasma display
(even in standby) as long as the power isn't
switched off.
02
19
En