Pioneer PRV-LX10 Operating Instructions Manual page 3

CAUTION
This product is a class 1 laser product, but this
product contains a laser diode higher than Class 1.
To ensure continued safety, do not remove any covers
or attempt to gain access to the inside of the product.
Refer all servicing to qualified personnel.
The following caution label appears on your unit.
Location: internal of the DVD drive unit
This product complies with the Low Voltage Directive
(73/23/EEC, amended by 93/68/EEC), EMC Directives
(89/336/EEC, amended by 92/31/EEC and
93/68/EEC).
Compliance with these directives implies conformity
to the following European standards.
• EN 60950-1: Product Safety
• EN 55103-1: Electromagnetic Interference
(Emission)
• EN 55103-2: Electromagnetic Susceptibility
(Immunity)
This product is intended for use in the following
Electromagnetic Environment(s):
E1 (residential),
E2 (commercial and light industrial),
E3 (urban outdoors) and
E4 (controlled EMC environment, ex. TV studio).
For pluggable Equipment, The Socket-Outlet Shall Be
Installed Near The Equipment and Shall Be Easily Accessible.
"Machine Noise Information Regulation 3. GPSGV: The
highest sound-pressure level is 70 dB(A) or less in
accordance EN ISO 7779".
If the AC plug of this unit does not match the AC
outlet you want to use, the plug must be removed
and appropriate one fitted. Replacement and
mounting of an AC plug on the power supply cord of
D3-4-2-1-9a_En
this unit should be performed only by qualified
service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make
sure it is properly disposed of after removal.
The equipment should be disconnected by removing
the mains plug from the wall socket when left
unused for a long period of time (for example, when
on vacation).
CAUTION
The POWER switch on this unit will not completely
shut off all power from the AC outlet. Since the
power cord serves as the main disconnect device for
the unit, you will need to unplug it from the AC outlet
to shut down all power. Therefore, make sure the
unit has been installed so that the power cord can
be easily unplugged from the AC outlet in case of an
accident. To avoid fire hazard, the power cord should
also be unplugged from the AC outlet when left
unused for a long period of time (for example, when
on vacation).
Confirm Supplied Accessories
Remote control unit (1)
AA batteries (2)
Air filter replacements set (1)
Operating Instructions (1)
Power cord (1)
Ferrite core (1)
• If any of the above accessories are missing,
contact your dealer.
CLASS 1 LASER PRODUCT
LASER KLASSE 1
D3-4-2-1-8_A_En
D3-4-2-2-1a_A_En
D3-4-2-2-2a_A_En
3
PRV-LX10
En