Example Of System Composition And Recording Component Setup; Prv-Lx10 - Pioneer PRV-LX10 Operating Instructions Manual

Example of System Composition and Recording Component Setup

7 System Composition
Note:
By installing the optional SDI
AES/EBU input board (PRA-
* (Must be purchased separately)
BD11) in the unit's expansion
slots, the PRV-LX10 can be
upgraded to support input of
SDI video signals and SDI/AES
EBU audio signals.
SDI AES/EBU Input Board
Note:
By installing the optional SDI
AES/IBU output board (PRA-
* (Must be purchased separately)
BD12) in the unit's expansion
slots, the PRV-LX10 can be
upgraded to support output of
SDI video signals and SDI/AES
EBU audio signals.
SDI AES/EBU Output Board
* BETACAM, Digital BETACAM, and DVCAM are registered
trademarks of Sony Corporation.
* DVCPRO is a registered trademark of Matsushita Electric
Corporation.
* Check Pioneer's website for a list of components and systems
with confirmed operational compatibility.
12

PRV-LX10

En
Input Board
(optional)
Video in
SDI
Audio in
SDI, AES/EBU
PRA-BD11
Output Board
(optional)
Video out
SDI
Audio out
SDI, AES/EBU
PRA-BD12
Video in/out
Component video
Composite video
S-video
✱
1 DV
Audio in/out
RCA
XLR
DV
Headphones
* (Must be purchased separately)
Video Monitor
* (Must be purchased separately)
Note:
At present, GUI is not output
from the VGA (GUI) output
connectors.
REC monitor / GUI display
Video out
Component video
Composite video
S-video
Writer 1 Writer 2
Supported discs:
DVD-R (general use),
DVD-RW
Remote
control unit
✱1
When using the DV cable, be sure to attach the
accessory ferrite core near the end of the cable
connected to this unit. Attach the ferrite core as shown.
* The ferrite core is provided to prevent interference with
surrounding appliances and this unit, in accordance with
European EMC standards (EN55103).
Installing the Ferrite Core
Connect to DV connector
on this unit.
Ferrite core
Cable
Internal HDD
HDD (USB connector)
* (Must be purchased separately)
Keyboard/mouse
(USB connector)
* (Must be purchased separately)
Insert the DV cable
into the groove of
the ferrite core, and
press together until
it clicks securely.
* In the event that
the DV cable is too
thin, double the
cable passage
through the core
as shown.