Standard Timer Recording - Pioneer DVR-320 Operating Instructions Manual

Recording
5 Use the (cursor left/right) to move the
cursor to the recording end time on the grid.
Recording start time
Easy Timer Recording
11: 00 12: 00 13: 00
13/12
14/12
15/12
13/12 11:45
WED
CHANNEL + / –
Pr 7 REC MODE
As you move the cursor around the grid, an arrow
stretches from the start time to the current cursor
position, representing the length of the recording. A
recording of up to six hours can be set.
6 Press ENTER to set the end time.
7 Select 'Yes' to set the timer recording and exit, or
'No' to go back to the timer recording screen.
• You can check the timer recording details you just set
from the main timer recording screen (see Standard
timer recording below).
Note
• You can't use VPS/PDC with Easy Timer Recording.
Use the standard or VIDEO Plus+ timer recording
methods if you want to use VPS/PDC.

Standard timer recording

The timer recording screen you can see all the timer
programs already set, clear programs and set up new
ones.
HOME
MENU
PREV NEXT
Recording end time
14: 00 15: 00 16: 00 17: 00
13:45
FINE
CLEAR
ENTER
TIMER REC
1 Press TIMER REC to display the Timer Recording
screen.
You can also access the Timer Recording screen from
the Home Menu (press HOME MENU, select Timer
Recording, then Timer Recording (View)).
This screen shows all the timer programs currently set.
Timer Recording
Date Start Stop
WED 13/12 7:00 8:00
New Input
DVD Remain
• Each row is for one timer recording program, with the
date and time information, channel, recording mode
and the VPS/PDC setting.
• The amount of free space available on the currently
loaded recordable DVD is shown towards the bottom
of the screen.
• In the lower-right corner, the number of timer
programs already set and the number that use VPS/
PDC, is shown next to Tmr Pgms.
• If there are more than eight timer programs already
set, press NEXT
to switch page (go back using
the PREV button).
• You can also clear a timer program before it's started
(before the recorder enters timer recording standby)
by highlighting it and pressing CLEAR.
2 Select 'New Input' to set a new timer program,
then press ENTER.
Timer Recording
Date Start
12/12 TUE 10 00
VPS/PDC
Program Set
OFF
3 Enter the timer recording settings.
Use the (cursor left/right) buttons to select a field;
use the (cursor up/down) buttons to change the
value.
• Date – Choose a date up to one month in advance, or
select a daily or weekly program.
• Start – Set the recording start time.
• Stop – Set the recording end time (maximum length
of a timer recording is six hours).
CH Mode VPS/PDC
Pr 3 SP Off
1/1
1h20m (SP)
Stop CH Rec Mode
11 00 Pr 7 SP
Ttl Name Input
06
49
En