Tuner Settings - Pioneer DVR-320 Operating Instructions Manual

The Initial Setup menu
• Mode1 – Through function only for the antenna
terminal
• Mode2 – No through function
• Off – Through function for both antenna terminal
and AV connector
Note
• When a timer recording is set with VPS/PDC on,
SCART through is always active.
Remote Control Set
• Default setting: Recorder1
You only need to set this if you are using more than one
Pioneer DVD recorder in the same room.
Initial Setup
Basic Clock Setting
Tuner Input Line System
Video In/Out On Screen Display
Audio In Front Panel Display
Audio Out Power Save
Language Remote Control Set
Recording Setup Navigator
Playback
So that each remote control operates only its own
recorder, make this setting different for each recorder
and remote in the room.
There are three different recorder IDs. When set to
Recorder2 or Recorder3, the remote control mode is
shown in the front panel display.
After selecting a new recorder ID, you have to confirm the
change by selecting Yes or No (use the
left/right) buttons), then pressing ENTER.
Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.
To set the remote, press and hold RETURN and a number
button (1, 2 or 3) until the indicator on the remote lights.
Setup Navigator
• Default setting: n/a
Initial Setup
Basic Clock Setting
Tuner Input Line System
Video In/Out On Screen Display
Audio In Front Panel Display
Audio Out Power Save
Language Remote Control Set
Recording Setup Navigator
Playback
The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.
See also Switching on and setting up on page 25.
Recorder1
Recorder2
Recorder3
(cursor
Start

Tuner settings

Auto Channel Setting : Auto Scan
This recorder has a built-in TV tuner for recording PAL B/
G, PAL I, SECAM L and SECAM D/K TV programs off the
air or from analog cable TV. We recommend that you first
use the Auto Channel Setting described here to tune into
the channels in your area, then if there are any unwanted
channels, you can disable them using Channel Skip
(described below).
1 Choose 'Tuner' from the Initial Setup menu, then
'Auto Channel Setting', then 'Auto Scan'.
Initial Setup
Basic Auto Channel Setting
Tuner Manual CH Setting
Video In/Out Channel Swapping
Audio In Set VIDEO Plus+ CH
Audio Out
Language
Recording
Playback
2 Select your country then press ENTER to start
tuning.
Initial Setup
Auto Channel Setting
Basic Auto Channel Setting Auto Channel Setting
Tuner Manual CH Setting
Country
Video In/Out Channel Swapping
Audio In Set VIDEO Plus+ CH
Audio Out
Language
Recording
Playback
• You can cancel before auto tuning has finished by
pressing ENTER again.
After auto scanning has finished, the channel mapping
screen appears showing which channels have been
assigned to which program numbers.
Initial Setup
Channel Mapping
Pr System CH Name
1 I 26
2 I 33
3 I 23
4 I 30
5 I 37
6 I 35
7 I 39
8 I 26
Use the PREV/NEXT buttons to display the previous/next
page.
3 Press HOME MENU to exit this screen.
Auto Scan
Download from TV
UK
1/7
Pr System CH Name
9 I 9
10 I 25
11 I 11
12 I 12
13 I 13
14 I 14
15 I 15
16 I 16
12
79
En