Standard Timer Recording - Pioneer DVR-520H Operating Instructions Manual

Recording
6 Press ENTER to set the end time.
7 Select 'Yes' to set the timer recording and exit, or
'No' to go back to the timer recording screen.
• You can check the timer recording details you just set
from the main timer recording screen (see Standard
timer recording below).

Standard timer recording

The timer recording screen you can see all the timer
programs already set, clear programs and set up new
ones.
HOME
MENU
PREV NEXT
ì
1 Press TIMER REC to display the Timer Recording
screen.
You can also access the Timer Recording screen from
the Home Menu (press HOME MENU, select Timer
Recording, then Timer Recording (View)).
This screen shows all the timer programs currently set.
Timer Recording
Date Start Stop
12/13 Wed 7:00 PM 8:00 PM
12/14 Thu 9:00 PM 10:00 PM
New Input
HDD Remain
DVD Remain
• Each row is for one timer recording program, with the
date and time information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on the HDD and
the currently loaded recordable DVD is shown
towards the bottom of the screen.
• In the lower-right corner, the number of timer
programs already set is shown next to Tmr Pgms.
• If there are more than eight timer programs already
set, press NEXT to switch page (go back using
the PREV
button).
CLEAR
ENTER
TIMER REC
CH Mode Rec to Confirm
Pr 3 FINE HDD OK
Pr 5 FINE HDD OK
10h20m (FINE)
1/1
0h43m (FINE)
• You can also clear a timer program before it's started
(before the recorder enters timer recording standby)
by highlighting it and pressing CLEAR.
2 Select 'New Input' to set a new timer program,
then press ENTER.
Timer Recording
Date Start
12/12 SUN 10 00
Rec to Group
HDD GROUP1
3 Enter the timer recording settings.
Use the (cursor left/right) buttons to select a field;
use the (cursor up/down) buttons to change the
value.
• Date – Choose a date up to one month in advance, or
select a daily or weekly program.
• Start – Set the recording start time.
• Stop – Set the recording end time (maximum length
of a timer recording is 24 hours for HDD recording or
six hours for DVD).
• CH – Choose a channel (1–99, excluding skip
channels), or one of the external inputs from which to
record.
• Mode – Select FINE, SP, LP, EP or AUTO (See
Recording time and picture quality on page 45). If
Manual Recording is on, then you can also select the
MN setting.
• Rec to – Select HDD for hard disk recording or DVD
for DVD recording. Select HDD
Recording (daily or weekly timer recording only).
• Group – Select a record group (for HDD recording
only).
• Ttl Name Input – Optionally, you can enter a name
for the recording up to 32 characters. (Highlight
Program Set then press
this option.)
4 After entering all the timer recording
information, highlight 'Program set' and press
ENTER.
The timer recording list screen is displayed again. The
timer program you just input appears in the list. The
rightmost column shows various timer recording status
messages:
• For an HDD timer recording, if there are already 250
titles on the HDD, the message Title Over appears.
• If a timer program overlaps another in the list, the
message Overlap appears.
Stop CH Rec Mode
Pr 7
-- -- FINE
Program Set
Ttl Name Input
for Auto Replace
(cursor down) to access
06
49
En