Table of Contents
Advertisement
Care and Cleaning
Operating the
Self-Cleaning Oven
Before Setting Oven Controls,
Check These Things:
Step 1:
Remove broiler pan, broiler rack
and other cookware from the oven.
(Oven shelves may be left in oven.
Note: Shelves may become gray
after several cleanings. )
Step 2:
Remove any combustible items
from the storage drawer. This
includes utensils with plastic
handles that can become overheated
and melt. Remove all utensils and
food from the cooktop.
Step
3:
Wipe up heavy soil on oven
bottom.
c
A. Oven Front Frame
Door Gasket
B. Oven
C. Openings in Door
D. Oven Light
Step
4:
Clean spatters or spills on oven
front frame (A) and oven door
outside gasket (B) with a dampened
cloth. Polish with a dry cloth. Do
not clean gasket (B). Do not allow
water to run down through openings
in top of door (C). Never use a
commercial oven cleaner
around self-cleaning oven.
Step 5:
Close oven door and make sure
oven light (D) is off.
How to Set Oven for Cleaning
Step 1:
Touch the OVEN CLEAN button.
C, 3:00
three hours cleaning time.
Step
CAUTION: Any time the OVEN
SET knob is set to clean position
and the door is not latched, a buzzing
sound will remind you to lock the
door promptly. Allowing the buzz to
continue for an extended time may
cause damage to the lock system so
that the door cannot be latched.
Step 2:
Rotate the door latch to its locked
position.
cleaning will begin.
Use of surface elements while
the range is self-cleaning is not
recommended.
in or
after about half an hour, the oven is
at cleaning temperature and the
oven door is locked.
is displayed to indicate
The buzzer will stop and
22
When cleaning is complete and
the oven has cooled below cleaning
temperature, the COOK POT
display goes out and the door may
be unlatched. Display returns to
time of day.
after cleaning has begun: Press
the OVEN CLEAN button twice
within, one second to cancel. When
COOK POT display goes out, door
can be unlocked.
To display time of day after
setting self clean cycle: Press and
hold CLOCK/SIGNAL OFF button.
How to Delay Start and Stop
of Self Cleaning
Step 1:
Make sure the range clock shows
the correct time of day.
Step
2:
Oven is preset to clean for 3 hours
but you may set clean for 2-4
hours. Less than 2 hours is not
recommended.
To change cleaning time, touch
OVEN CLEAN button and turn
ADJ. OVEN TIME-TEMP. knob to
your desired cleaning time.
Note: Preset cleaning cycle will
begin 4 seconds after touching
OVEN CLEAN button. If you still
want to change cleaning time,
touch OVEN CLEAN button twice
to cancel and begin again.
Step
3:
Touch STOP TIME button and turn
ADJ. TIME-TEMP. knob to the
time you want the self-clean cycle
to end. Be sure the stop time is 3 or
more hours later than the present
time of day.
Advertisement
Table of Contents
