Cactus V6 IIs User Manual page 27

The V6 IIs is equipped with an autofocus assist LED and is capable of supporting the
auto-focus assist signal from configured camera system. The power of the LED light
could be adjust to best suit your working environment.
To configure the AF assist LED:
1. Switch on the V6s in TX or RX mode, press
<SUB-MENU>. Press
2. Turn the selection dial to <AF-ASSIST POWER>, press
able to turn on and select the power of the AF assist LED.
Note: The V6 IIs TX completely replicates the AF signal commanded by the connected
camera. If the camera does not support AF assist signal via the hot shoe, the AF
assist LED would not be activated.
15.2 Multi-master
The V6 IIs supports up to 16 TXs working together in a lighting set up. Photographers
can share the same set of remote flashes and command them to fire the power
output without being influenced by the others.
There is no need to configure on the V6 IIs menu to support multi-master. By the
time the any of the photographer in the group presses the shutter, the V6 II TX would
trigger the RXs and command the flash to fire the configured power levels from that
specific TX.
Note: If two TXs are triggering at the same time, the RXs may interfere with each
other. It is recommended to the photographers in the set up to shoot one by one.
15.3 Delay Timer
(image)
Every V6 IIs is equipped with a delay timer that is configurable in either the TX or RX
mode. The delay timer delays the trigger response for the time period set. If you wish
to f ire the flash a bit later than the first curtain sync to create a different light effect
(e.g., to achieve a second curtain sync), set an appropriate delay time from 1
millisecond to 99 seconds.
.
, and turn the selection dial to
. You would then be