Speaker Reassembly; Dust Cover Assembly; Chassis And Front Cover Reassembly - Motorola CP150 Basic Service Manual

2-8
3. Press the PTT assembly against the front cover opening (Figure 2-8b).
a. Place bottom tab into bottom slot.
Place top tab into top slot.

2.6.3 Speaker Reassembly

1. Align the speaker as shown in Figure 2-9.
2. Insert the top of the speaker under the two rails in the housing.
3. Place the speaker retainer bracket onto the two screw bosses. Make sure the tab fits into the
retainer bracket slot.
4. Use the T6 Torx screwdriver to fasten the screws holding the retainer bracket to the front cover.
Tighten to 2 in/lb.

2.6.4 Dust Cover Assembly

a. Insert the dust cover key into the housing at a 90° angle.
b. Rotate the dust cover 90° in a clockwise direction to allow the key to fully insert into the
housing.
c. Press the key and dust cover into the housing.

2.6.5 Chassis and Front Cover Reassembly

1. Dress and connect the speaker wires.
NOTE: Care should be taken when dressing the speaker wires to avoid pinching them between the
speaker magnet and shield, under the microphone boot or between the accessory
connector and housing.
a. Form the wires into an "M" shape so it can collapse on itself like an accordion with all of
the wire up in the top corner of the radio away from the shields. Place three bends in the
wires spaced approximately 1cm apart to give the wire an "M" shape (Figure 2-11).
b. Push down on ribs toward bottom
of radio so hooks do not get crushed.
Figure 2-8. PTT Assembly
Figure 2-9. Speaker Assembly
Radio Reassembly — Detailed
Rails
Screw Bosses