Motorola CP150 Basic Service Manual page 50

4-16
4. Press and hold the two side buttons at the same time on the source radio and then power up the
source radio (Figure 4-3). Both radios produce a "clone-entry" tone.
5. Release both side buttons, 1 and 2.
6. When cloning is completed, the source radio produce's a "clone-exit" tone and both the source
and destination radios reset.
7. Turn both radios off.
8. Disconnect the cloning cable from both radios and turn them on for normal operation.
Side Button 1
Side Button 2
Figure 4-3. Side Button Locations
Radio-to-Radio Cloning