Rssi System Level Tuning - Motorola CP150 Basic Service Manual

4-14
4. Adjust the softpot value by using the slider, keying in the edit box or using the spin controls. Press
ENTER to confirm the selection or use the spin controls. Do this until the radio is totally unmuted.
Verify the squelch closing by inputting a signal level of 4 dB lower than that of the 10 dB SINAD
level.
5. Repeat Steps 2 through 4 of Manual Squelch Tuning, for frequency points F2-F7.
6. Press Program to commit the softpot values into the radio.
7. Exit the Squelch Tuning function.
4.5.2.2 Auto Tune
Note: Proceed with caution since this procedure automatically programs the softpot value
into your radio.
When you press the Auto Tune button, the radio automatically returns an optimum squelch value.
After you press the button, the radio may need time to produce an optimal setting for the squelch
attenuation. The following steps describe the auto tune process:
1. Select current frequency point (F1 being the first), then press Auto Tune.
2. Repeat Steps 3-4 of the Manual Squelch Tuning section for frequency points F2-F7.
Note: Auto Tune will automatically update your radio's codeplug. Please be careful when
using it.

4.5.3 RSSI System Level Tuning

1. Under the Rx Align menu, select RSSI Tuning (Figure 4-1).
2. Inject an on channel signal to the radio at -47 dBm at the frequency listed. Modulate the signal
with a 1 kHz tone at 60% deviation (3 kHz) to verify that the radio is receiving the desired fre-
quency. RSSI tuning is only done at 25 kHz channel spacing.
3. Change the level to the defined dBm level in the softpot box. (-115 dBm or -105 dBm).
4. Press the Update button for the softspot to be tuned to the RSSI value correlating to the applied
level. The programmed RSSI value will be displayed.
5. Adjust the input level to reflect the next softspot value. Repeat steps 3 and 4 to tune the next
value.
Figure 4-1. RSSI Tuning
Receiver Tuning