Sanyo VPC-WH1W Service Manual page 13

1. Spacer bottom
2. Four screws 1.7 x 5
3. Ring lens
4. Dec front
4-A. Adhesive front A
4-B. Adhesive dec back 4
4-C. Spacer mic filter j
5. Four screws 1.4 x 4
6. Two screws 1.7 x 5
7. Dec grip
8. Spacer sw top
9. Four screws 1.7 x 5
10. Dec back
11. Holder button
12. Button shutter
13. Button movie
14. Button shutter in
14-A. Spacer pad back
15. Screw 1.7 x 5
16. Dec LED
17. Two screws 1.7 x 5
18. Dec top
19. Two screws 1.7 x 3
20. Dec DC
21. Four screws 1.7 x 4.5
22. Assy, dec joint
22-A. Spacer cover air
23. Two screws 1.7 x 7
24. Five screws 1.7 x 5
25. Compl, cabinet R LCD
26. FPC
27. Gasket screw
28. Screw 1.7 x 4
29. Holder right FL
30. Screw 1.7 x 3
31. Holder terminal batt
32. Remove the solder.
33. Four screws 1.7 x 5
34. FPC
35. Shaft cover DC
36. Spring cover DC
37. Compl, cover DC
38. Pad DC
39. Spacer pad DC
40. Two screws 1.7 x 3
41. Holder DC
42. Two screws 1.7 x 4.5
43. Holder lock DC
44. Screw 1.7 x 4
45. Gasket screw
46. Screw 1.7 x 3
47. Earth cover batt
48. Shaft cover batt
49. Two screws 1.7 x 3
50. Shaft cover SD
51. Compl, dec left back sv
52. Assy, cover batt sv
53. Screw 1.7 x 3
54. Four screws 1.7 x 5
55. Stand
56. Four screws 1.7 x 3
57. Holder battery
When reassembling
The air leak test should
be carried out between
steps 22-A and 23.
At this time, the battery
cover should be closed
and locked.
After finishing the air leak
test, attach the new 22-A.
– 13 –
NOTE: Discharge a strobe capacitor
with the discharge jig (VJ8-0188) for
electric shock prevention.