Connecting Using The S-Video Output; Connecting Using The Component Video; Output - Pioneer DV-210K-K Operating Instructions Manual

Connecting using the S-Video

output

(except for DV-210K)
If your TV (or other equipment) has an S-Video
(S1) input, you can use the S-Video output on
this player instead of the standard (composite)
output for a better quality picture.
• Use an S-Video cable (not supplied) to
connect the S-VIDEO OUT to an S-Video
input on your TV (or monitor or AV
receiver).
Line up the small triangle above the jack with
the same mark on the plug before plugging in.
TV
VIDEO OUT DIGITAL
AUDIO OUT
P
B
COAXIAL
P Y
R
HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT OPTICAL
DV-410V
To S-Video input
AUDIO OUT
L
R
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other
equipment). This should give you the best
quality picture from the three types of video
output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
TV
VIDEO OUT
DIGITAL
AUDIO OUT
P
B
COAXIAL
P Y
R
HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT OPTICAL
DV-410V
Watching progressive scan video
from the component video
outputs
This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see Video Output settings on page 36.
When the player is set to output progressive
scan video, the PRGSVE
front panel display.
To component
video input
AUDIO OUT
L
R
indicator lights in the
02
11
En