Setting The Tv System; Resetting The Player; Dvd-Video Regions; Selecting Languages Using The Language Code - Pioneer DV-210K-K Operating Instructions Manual

Setting the TV system

09
(Except Taiwanese model)
The default setting of this player is
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to AUTO . If you experience picture
distortion with some discs, set the TV system
to match your country or region's system.
Doing this, however, may restrict the kinds of
disc you can watch. The table below shows
what kinds of disc are compatible with each
setting ( AUTO , NTSC
If the player is on, press  STANDBY/
1
ON to switch it to standby.
2 Using the front panel controls, hold
down  then press  STANDBY/ON to
switch the TV system.
The TV system changes as follows:

• AUTO NTSC

• NTSC PAL

• PAL AUTO
Note
• You have to switch the player into standby
(press  STANDBY/ON) before each
change.
Disc Type
Format NTSC
DVD/ NTSC
Super VCD/
Video CD/
PAL
DivX video/
WMV
CD/MP3/
WMA/
MPEG-4 AAC —
/JPEG
no disc
44
En
AUTO , and
and PAL ).
Player setting
PAL AUTO
NTSC PAL NTSC
NTSC PAL PAL
NTSC
NTSC PAL
or PAL

Resetting the player

Use this procedure to reset all the player's
settings to the factory default.
1 Switch the player into standby.
2 Using the front panel buttons, hold
down the  (stop) button and press
 STANDBY/ON to switch the player back
on.
All the player's settings are now reset.

DVD-Video regions

All DVD-Video discs carry a region mark on the
case somewhere that indicates which
region(s) of the world the disc is compatible
with. Your DVD player also has a region mark,
which you can find on the rear panel. Discs
from incompatible regions will not play in this
player. In this case the attention sentence
Incompatible disc region number Can't play
is displayed on screen. Discs marked
disc
will play in any player. The diagram below
shows the various DVD regions of the world.
1
2
4
Selecting languages using
the language code list
Some of the language options (such as 'DVD
Menu Lang.' in the Initial Settings) allow you
to set your preferred language from any of the
136 languages listed in the language code list
on page 50.
1 Select 'Other Language'.
Use the / (cursor left/right)
2
buttons to select either a code letter or a
code number.
Use the / (cursor up/down) buttons
3
to select a code letter or a code number.
See Language code list on page 50 for a
complete list of languages and codes.
ALL
5
1
6 2
3
5
2
4