Quick Reference Guide
Comfort Pad Replacement
Removal
Hold and pull Comfort Pad out of the Barcode Imager.
Installation
Position the Comfort Pad onto the Imager as
1.
shown.
Press the Comfort Pad onto the Imager. When
2.
properly installed, the Comfort Pad "locks" into
place.
Trigger Assembly Replacement
Removal
Turn the Imager upside-down.
1.
Remove the Comfort Pad.
2.
Rotate the Trigger Assembly to
3.
align with the back of the Imager.
Use a paper clip or similar object to
4.
press the Release Latch.
Lift the Trigger Assembly off the
5.
scan assembly.
Installation
Turn the Imager upside-down.
1.
Position the Trigger Assembly to
2.
align with the back of the Imager.
Lower the Trigger Assembly to
3.
the scan assembly.
Rotate Trigger Assembly 1/4 turn
4.
counterclockwise.
Press the Comfort Pad onto the
5.
Imager. When properly installed,
the Comfort Pad "locks" into
place.
1
Release Latch
2
1
3
Imager Back
2
Triggerless
Finger Clamp
19