Setting An Indoor Unit Address And Installation Option - Samsung AC***MNADKH Installation Manual

Setting an indoor unit address and installation option

• Set the indoor unit address and installation option
with remote controller option. Set the each option
separately since you cannot set the ADDRESS setting
and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit
address and installation option.
• Please use the proper wireless remote controller which
can set 24 digit option code.
• Please refer to the wired remote controller installation
manual for setting with the wired remote controller.
Common steps for setting the addresses and
options
Entering mode for
setting option
High Temp Button
Low Temp Button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
Option setting
2 Set the option values.
mode
• The total number of available options are 24: SEG1 to
SEG24.
Mode change
• Because SEG1, SEG7, SEG13, and SEG19 are the page
High Fan Button
options used by the previous remote control models,
Low Fan Button
the modes to set values for these options are skipped
automatically.
• Set a 2-digit value for each option pair in the
following order: SEG2 and SEG3
→
SEG12
SEG18 and SEG20
SEG24
SEG1
0
SEG7
1
SEG13
2
SEG19
3
On (SEG1 to SEG12)
a Remove the batteries from the remote control,
and then insert them again.
While holding down the
b
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
CAUTION
→
SEG6 and SEG8 SEG9 and SEG10
→
SEG14 and SEG15
→
SEG21 and SEG22
SEG2 SEG3 SEG4
X X
SEG8 SEG9 SEG10
X X
SEG14 SEG15 SEG16
X X
SEG20 SEG21 SEG22
X X
(High Temp) and
→
SEG4 and SEG5
→
SEG11 and
→ →
SEG16 and SEG17
→
SEG23 and
SEG5 SEG6
X X X
SEG11 SEG12
X X X
SEG17 SEG18
X X X
SEG23 SEG24
X X X
Off (SEG13 to SEG24)
English 17