Table of Contents
Advertisement
4.1
Desktop Mounting
The device can be placed on a desktop when its four anti-slide bumpers
(supplied) are attached to the underside of the device.
To attach the anti-slide rubber bumpers to the device:
1.
Flip the device over so that its underside faces up.
2.
Locate the four anti-slide grooves on the underside - one in each
corner.
Peel off the adhesive, anti-slide rubber feet and stick one in
3.
each anti-slide groove.
Figure 4-1: Location for Applying Rubber Feet
·
1 = Mounted anti-slide rubber feet
·
2 = Anti-slide groove
4.
Flip the device over again so that it rests on the rubber feet and
place it in the required position on a desktop.
4.2
19-Inch Rack Mounting
The device can be installed in a standard 19-inch rack by implementing one of
the following mounting methods:
● Placing it on a pre-installed shelf in a 19-inch rack
Advertisement
Table of Contents
