Table of Contents
Advertisement
Item
Label
#
1
POWER / STATUS
2
//
3
CONSOLE
4
LAN
5
PRI
6
USB
Table 3-2: Front Panel Description
Description
LEDs indicating the status of the power and
reboot/initialization.
Reset pinhole button for resetting the device and
optionally, for restoring the device to factory
defaults. To restore the device to factory defaults,
do the following:
With a paper clip or any other similar pointed
object, press and hold down the pinhole button for
at least 12 seconds, but no longer than 25
seconds
RJ-45 port for RS-232 serial communication
Up to four Gigabit Ethernet (10/100/1000Base-T)
ports for connecting to LAN network (IP phones,
computers, or switches). These ports support half-
and full-duplex modes, auto-negotiation, and
straight or crossover cable detection.
Single E1/T1 port interface (RJ-48).
Note: PRI interface is a customer-ordered item.
Two USB 2.0 ports, which can be used, for
example, for various storage capabilities using an
external USB hard drive or flash disk (disk on key).
Advertisement
Table of Contents
