Table of Contents
Advertisement
To earth the device:
1.
Connect an electrically earthed strap of 16 AWG wire (minimum)
to the chassis' earthing screw (located on the rear panel), using the supplied
washer.
2.
Connect the other end of the strap to a protective earthing. This
should be in accordance with the regulations enforced in the country of
installation.
5.2
Connecting to the LAN
The device provides up to four Gigabit Ethernet (10/100/1000Base-T) ports
for connection to the LAN (e.g., computers, switches, and IP phones). These
ports support half- and full-duplex modes, auto-negotiation, and straight or
crossover cable detection.
The RJ-45 connector pinouts are described in the table below:
Table 5-1: RJ-45 Connector Pinouts for GbE
Pin
Signal Name
1
Ethernet signal pair (10/100/1000Base-T)
2
3
Ethernet signal pair (10/100/1000Base-T)
6
4
Ethernet signal pair (1000Base-T)
5
7
Ethernet signal pair (1000Base-T)
8
Figure 5-1: Earthing the Device
Advertisement
Table of Contents
