Table of Contents
Advertisement
Shield
Chassis ground
To connect the device to the LAN:
1.
Connect one end of a straight-through RJ-45 Cat 5e or Cat 6
cable to the RJ-45 port labeled S1 / LAN GE.
2.
Connect the other end of the cable to the Gigabit Ethernet
network.
5.3
Connecting to an ISDN PRI (E1/T1) Trunk
The procedure below describes the cabling of the device's E1/T1 (PRI) trunk
interface.
Warning:
AWG min wire to
Note:
PRI interface is a customer-ordered item.
Figure 5-2: Cabling the LAN Ports
To protect against electrical shock and fire, use a 26
connect the E1 / T1 port to the PSTN.
Advertisement
Table of Contents
