Table of Contents
Advertisement
Attach the two mounting brackets (supplied) to each side of the
1.
device's chassis, using the supplied screws, as shown in the figure
below:
Figure 4-4: Attaching the Mounting Brackets
·
1 = Left mounting bracket
·
2 = Attached screws
·
3 = Right mounting bracket
1.
Place the device on a pre-installed shelf in the rack.
2.
Attach the ends of the mounting brackets (that you installed in Step 1)
to the vertical track of the rack's frame, using standard 19-inch rack bolts (not
supplied).
5
Cabling the Device
This section describes the cabling of the device, which includes the following:
Grounding (earthing) the device
Connecting to the LAN
Connecting to an E1/T1 trunk
Connecting to a computer for serial communication
Connecting a USB storage device
Connecting to the power supply
5.1
Grounding the Device
The device must be connected to earth (grounded) using an equipment-
earthing conductor.
Advertisement
Table of Contents
