Table of Contents
Advertisement
5.5
Connecting a USB Storage Device
The device supports USB storage capabilities, using an external USB hard drive
or flash disk (disk on key) connected to the device's USB port. The storage
capabilities are configured through CLI and include the following:
● Saving network captures to the USB
● Updating the device's firmware from the USB
● Updating the device's configuration from the USB
● Saving the current configuration to the USB
To connect the USB storage device:
● Connect the USB storage device to one of the USB ports located on the
front panel.
Figure 5-7: Connecting a USB Storage Device
Note:
Only a single USB storage (formatted to FAT/FAT32) operation
is supported at any given time.
Advertisement
Table of Contents
