Connecting Up For Analog Playback & Recording - Pioneer PDR-509 Operating Instructions Manual

Connecting Up for Analog Playback & Recording
Before you start, make sure that all the components are
switched off and disconnected from the wall outlet.
Next, connect this unit to your amplifier/receiver using the
two sets of supplied audio leads—one set for playback,
the other for recording. On the rear panel of your amplifier
find an unused set of inputs /outputs for a tape/
PDR–509 CD-Recorder
LINE IN
R L
R
L
Supplied stereo
audio cords
R L
MD/TAPE
OUTPUT INPUT
REC PLAY
L
R
Amplifier
Note: Rear panel show is that of U.S. and Canadian
models; others may look slightly different.
MD
LINE OUT CONTROL DIGITAL IN
OPTICAL COAXIAL
R L
IN
R L
L
R
OUT
CONTROL
Pioneer Î out
recorder (check the instruction manual that came with your
amplifier if you're unsure about which terminals to use).
Using this set up you can make recordings from any other
component connected to the amplifier, via the analog
inputs of this unit.
DIGITAL OUT
OPTICAL COAXIAL
Connecting Other Pioneer
Î Components
If you are using a Pioneer amplifier or receiver that has
this feature, you can control this unit with the multi-
remote controller that came with your amplifier/receiver.
The advantage of this is that you can use a single
remote control to operate several components. Check
the instruction manual that came with your amplifier or
receiver for more information on using its remote as a
multi-controller.
Use a commercially available cord with a mono mini-
plug at either end to connect the
terminal of the amplifier/receiver to the
terminal of this unit.
Make sure that at least one set of analog terminals is
connected to the amplifier when using Î control
cords.
Connecting Up
AC IN
To wall outlet.
CONTROL OUT
CONTROL IN
11