Software Setup; Test The Setup - Native Instruments Audio 2 DJ Operation Manual

Software Setup

1. Start TRAKTOR.
2. Open Preferences > Audio Setup > Audio Setup.
3. From the Audio Device list, select the AUDIO 2 DJ entry.
4. Open Preferences > Audio Setup > Output Routing.
5. Choose Internal Mixing Mode.
6. Assign 1: Out and 2: Out to the Output Master.
7. Assign 3: Out and 4: Out to the Output Monitor for pre-listening to the Tracks.
8. Close the Preferences.
9. Turn up the volume of your amplifier to the level you would like to use during your
performance.
10. Play a track and double-click the M
to set the output volume amplification in the software to 0 dB. Adjust the output vol-
ume of the Audio 2 DJ with the Volume Control for Output A on the left side of the
AUDIO 2 DJ.
11. Turn the M knob fully to the left and activate the H
ix
strip of the playing deck. Double-click the VOL knob in the Master panel to set the
headphone output amplification to 0 dB. Finally adjust the headphone volume with
the Volume Control for Output B on the right side of the Audio 2 DJ.

Test the Setup

1. From TRAKTOR 's Browser List, drag tracks in both decks and hit the Play/Pause
Buttons.
2. Drag the crossfader all the way to the left (Deck A).
3. Click on the H C
eadpHone
Deck B in your headphones while the track in Deck A is playing via your speakers.
V knob in the Master panel of TRAKTOR
ain oluMe
button next to Deck B. You should hear the track playing on
ue
C button in the mixer
eadpHone ue
AUDIO 2 DJ – 28