Inspection Instructions - ICARO paragliders Sitta Manual

Table of Contents

Advertisement

Page 21

Inspection Instructions

Record Information
Spread out your paraglider in a big bright room and make a note of information
such as model, type and serial number.
Porosity Test
Use your porosity meter to perform porosity checks at 4 different places of the
canopy. The results are recorded in the inspection protocol and are to be
evaluated according to the internal guidelines of the workshop.
Visual Control of the Canopy
Hang up the canopy so that you can do a visual check of your canopy. Check for
perforations in the upper and lower sailcloth, damaged stitching between the cells,
and damage to the leading/trailing edge reinforcements.
Each cell must be checked.
Visual Control of the Risers and Lines
Check the risers, the trimmers, the stitching at each line loop, the brake lines, all
seams and line contact points. Each line must be measured and inspected for
kinks.
Strength test of the lines
One complete A-and B- line must be removed, measured and submitted to a
strength test. The measured value of each individual line must be noted in the
inspection protocol. The minimum of the lines strength are 125% of the normative
guidelines.
Measurement of the lines
Measure every single line while stressing it with defined tractive force (5daN). The
results are recorded in the inspection protocol and are to be evaluated according
to the internal guidelines of the workshop.
All information about the lines (single length, total length, mechanical
strength) please call ICARO paragliders,
office@icaro-paragliders.com
Assessment
The measurements of all procedures are noted in the inspection protocol. When all
facts have been recorded, the technician must make a general assessment.
Check the backpack for damage to the zips, seams and straps and repair if
necessary with a sewing machine.
General Remarks
Any other repairs, corrections etc. to the general condition of the paraglider must
be evaluated. A copy of the results of each inspection must be sent on to ICARO
Paragliders.
The technician must report any unusual faults to ICARO paragliders within
3 days.
Inspection Reference
Only an authorized technician who has been trained by ICARO paragliders is
authorized to sign and date the glider type label and sign the manual.

Advertisement

Table of Contents
loading

Table of Contents