Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Celsi 16" Electriflame XD series
Summary of Contents for Celsi 16" Electriflame XD series
- Page 1 16” Electriflame XD Packing Checking List Package 1 1 off Electric fire 1 off Remote control handset 2 off AAA batteries 1 off Instructions manual 1 off Decorative fret (if ordered) 1 off Decorative frame THIS INSTRUCTION BOOKLET MUST BE LEFT WITH THE USER...
-
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS This fire must be installed by a qualified, competent person. A. Location 1. The 16” x 22” versions of this fire is designed to be installed into a fireplace with a opening of 560mm in height by 420mm in width. The 22” x 22” version is designed to be installed into a fireplace with a opening of 560mm in height by 580mm in width. - Page 3 THE INSTALLER SHOULD EXPLAIN FULLY HOW TO OPERATE THE APPLIANCE OPERATING INSTRUCTIONS Please read these instructions carefully before attempting to use the appliance and retain for future use. 1. When the fire is in operation certain areas will get hot. Caution must be taken to avoid being burned.
- Page 4 Control panel on Fire The control panel is located behind the louvers. Press where indicated to open louver panel. The center of the louvers will get hot when the heater is switched on. On/off Isolating Switch Flame Effect Dimmer Switch Low Heat 900W High Heat 1800W Remote Control...
-
Page 5: Technical Specification
TECHNICAL SPECIFICATION Power Supply 230V AC 50Hz General Power 1800W Heat Power 900W 1800W Flame Effect Heater has an over heating power cut off safety feature. MAINTENANCE INSTRUCTIONS Cleaning the Fire Switch off the power to the fire and allow it to cool before cleaning. Use a soft damp (not wet) cloth. - Page 6 Part NO.: B-174600-2(X) B-174600-2(S) Issue 4 BFM Europe Ltd Gordon Banks Drive Trentham Lakes Stoke-on-Trent ST4 4TJ Telephone (General Enquiries) 01782 339000 Telephone (Service ) 01782 339008...
Need help?
Do you have a question about the 16" Electriflame XD series and is the answer not in the manual?
Questions and answers