www.freeservicemanuals.info
NOTE: All System Level Calibrations are retained in
permanent memory and will change only if calibration
is performed again. The factory default setting for the
volume control is 75.
Manual
System
Calibration
NOTE: The front panel CHANNEL STATUS LEDs will light to
indicate which channel is reproducing the test signal. A
more convenient method of manually switching the test
signal is to use the SP push-button on the optional
HR34/HR39/HR130 Remote Control which performs the
same functions as the SYS CAL push-button.
NOTE: All System Level Calibrations are retained in permanent
memory and will change only if calibration is
performed again. The following table may be used to
record your Delay Calibrations Settings.
Figure 5
Calibration Channel
Left Front
Center Front
Right Front
Right Surround
Left Surround
Subwoofer
Digitized in Heiloo Netherland
System Level Calibration
Default Setting
0
0
0
0
0
0
5/10/2017
cont
New Setting
15