Removing Driveline Guard - MacDon FD75 Operator's Manual

5.6.3 Removing Driveline Guard

The main driveline guard must remain attached to the driveline during operation, but it can be removed for
maintenance purposes.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
NOTE:
The driveline does NOT need to be removed from the adapter in order to remove the driveline guard.
1. Shut down the combine, and remove the key from
the ignition.
2. If the driveline is in the storage position, rotate disc (B)
on the adapter driveline storage hook (A), and remove
the driveline from the hook. If the driveline is attached to
the combine, remove the driveline from the combine by
pulling the quick disconnect collar to release the
driveline yoke at the combine shaft. Refer to
Attachment/Detachment, page
3. Lift the combine end of the driveline (A) from the hook,
and extend the driveline until it separates. Hold the
adapter end of the driveline (B) to prevent it from
dropping and hitting the ground.
214323
MAINTENANCE AND SERVICING
4 Header
269.
351
Figure 5.42: Combine End of Driveline
B
Figure 5.43: Separated Driveline
E
D
A
Revision A