Front Section Reassembly - Eaton TRSM0515 Service Manual

FRONT SECTION REASSEMBLY

Il. FRONT SECTION REASSEMBLY
A. To Install the Right Reverse Idler Gear
Assembly.
1. Apply a heavy coat of white grease on the
reverse-idler gear front washer and install it on
pin in lower right of case.
2. Set reverse gear in position next to washer,
machined surface of gear hub to the rear.
3. Install needle bearing through rear bore and in-
to hub of reverse gear.
4. Place rear washer in holder if previously remov-
ed, and bend lugs to secure washer.
5. Place washer and holder into reverse gear case
bore, holder flange to the rear.
6. Install the auxiliary countershaft front bearing
into the reverse gear case bore to hold the
reverse idler gear assembly in position.
NOTE: The front portion of the auxiliary counter-
shaft is used as a journal for the reverse idler
gear.