Front Section Disassembly - Eaton TRSM0515 Service Manual

FRONT SECTION DISASSEMBLY

5. Using soft bar and maul against front of
countershaft, move the countershaft assembly
to the rear as far as possible. This will move
front bearing forward on shaft.
6. Using soft bar and maul against rear of counter-
shaft, again move the countershaft as far for-
ward as possible to unseat front bearing from
case bore.
7. Use puller or pry bars to remove front bearing.
8. Use a maul and punch from inside the case to
drive the rear bearing to the rear and from the
case bores.
NOTE: Removal procedures will damage the
bearings and removal should not be attempted
unless replacement of the bearings is planned.