Lenovo RackSwitch G8296 Installation Manual page 84

3. Set the new switch to use the Machine Type-Model (MTM) number of the old unit.
4. Set the new switch to use the serial number of the old unit. For example:
5. Reset the switch using the following command:
6. When prompted for confirmation, enter <y>. The switch will then restart.
84
G8296 Installation Guide
For example:
for Lenovo Enterprise Network Operating System (ENOS):

G8296(config)# boot mtm 1234-56X
New MTM value: 1234-56X
Please reset the system for the new changes to take effect
 for Lenovo Cloud Network Operating System (CNOS):
G8296(config)# hardware mtm 1234-56X
New MTM value: 1234-56X
Please reset the system for the new changes to take effect
where 1234-56X is the MTM from your old unit.
Note: The MTM shown here is merely an example. Use the actual MTM recorded
from your old G8296 unit.
 for Lenovo Enterprise Network Operating System (ENOS):
G8296(config)# boot esn XX01234567
 for Lenovo Cloud Network Operating System (CNOS):
G8296(config)# hardware esn XX01234567
where XX01234567 is the serial number of your old unit.
Note: The serial number shown here is merely an example. Use the actual serial
number recorded from your old G8296 unit.
G8296# reload