1. Locate, record, and retain the product switch information in order to configure and
2. Attach the front mounting brackets (Item 1) to each side of the switch with M4
44
G8296 Installation Guide
To install the G8296 in a System x or Power rack, complete the following steps:
register your product. See
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch and
affix the new label to the bottom of the new switch.
screws (Item 2). Torque the screws to approximately 2.0 newton-meters (Nm) ± 0.1
Nm (17.7 inch-pounds).
"Before Installing the G8296" on page
1
34.
2