Operation And Controls - Whynter BOR-53024-SSW Instruction Manual

Operation and Controls

It is recommended you install the appliance in a place where the ambient temperature is between 60°F - 90°F / 16°C -
32°C. If the ambient temperature is above or below recommended temperatures, the performance of the beverage
refrigerator may be affected. For example, placing your appliance in extreme cold or hot conditions may cause interior
temperatures to fluctuate.
POWER
To turn on or off the beverage refrigerator, press the Power
SETTING THE TEMPERATURE
The temperature controls are locked automatically by default. To change, unlock the temperature setting by
pressing the SET button. Press the Up
temperature. Temperature controls are automatically locked after 5 seconds.
To view the set temperature at any time, press the SET
seconds and will revert back to current internal temperature.
NOTE:
• The temperature inside the beverage refrigerator is dependent on the ambient temperature.
• The RUN light is illuminated when the cooling cycle unit is in operation. Once the unit reaches the set temperature,
the RUN light will shut off.
• The factory preset temperature is 40°F / 4°C.
FAST COOL MODE (FF)
When you set the outdoor refrigerator in Fast Cool mode, the refrigerator will rapidly cool the unit to 28°F/-2°C.
Once the temperature reaches 28°F/-2°C, the compressor will turn off and the Fast Cool mode will be disabled.
Once the internal temperature reaches 5°F/2°C degrees higher than the current set temperature, the compressor
will turn on and cool to reach the previous set temperature.
To activate the Fast Cool mode when the unit is on, press and hold the SET
seconds. The temperature display window will display "C1" when unit Fast Cool mode is activated. To cancel,
press the SET and LIGHT
Fast Cool mode is deactivated.
DOOR ALARM
If the door has been left open for more than 1 minute, the alarm will sound. The alarm will stop by closing the door.
REFRIGERATOR ALARM
This outdoor refrigerator has an alarm system feature that activates when the unit detects any malfunction in the
refrigerator system. If the temperature display window displays "LI", "EI", or "HI", please proceed to the
Troubleshooting section of this user manual.
ºC and ºF SELECTOR
To change temperature conversions, press the
INTERIOR LIGHT
You can turn on and off the interior light by pressing the Light
LEVELING THE APPLIANCE
It is important for your appliance to be leveled in order to work properly. It can be raised or lowered by rotating each
of the feet on the bottom of the machine. If you find that the surface is not level, rotate the feet until the appliance
becomes level .You may need to make several adjustments to level it. We recommend using a carpenter's level to
check the machine.
NOTE: The Whynter BOR-53024-SSW has 4 leveling legs.
FF
button to raise the set temperature or Down
buttons for 5 seconds. The temperature display window will display "C0" when unit
button to switch between temperature conversions.
button.
button. The "set" temperature will temporary flash for 5
and LIGHT
button on the control panel.
10
button to lower the set
buttons for 5