Tuner
Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 22.
1
(
) indicator
STEREO
ST
Shows that the frequency selected is being
broadcast in stereo.
2
indicator
BAND
Shows which band the radio is tuned to, AM
or FM.
3
indicator
PRESET NUMBER
Shows what preset has been selected.
4
indicator
FREQUENCY
Shows to which frequency the tuner is
tuned.
1 Press
to select the tuner
SOURCE
Press
until you see
SOURCE
• Pressing
on the head unit also per-
SOURCE
forms the same operation.
2 Use
to adjust the sound level.
VOLUME
Press
to increase or decrease the vol-
VOLUME
ume.
• Rotating
on the head unit also
VOLUME
increases or decreases the volume.
3 Press
to select a band
BAND/ESC
Press
until the desired band is dis-
BAND/ESC
played,
,
,
FM1
FM2
FM3
• Pressing
BAND/ESC
performs the same operation.
1
2 3
4
.
displayed.
Tuner
.
for FM or
.
AM
on the head unit also
4 To perform manual tuning, press 1 or
¡ with quick presses.
The frequencies move up or down step by step.
2
3
• Pressing
or
on the head unit also per-
forms the same operation.
5 To perform seek tuning, press and hold 1
or ¡ for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
1 or ¡ with a quick press.
• If you press and hold 1 or ¡ you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
2
3
• Pressing
or
on the head unit also per-
forms the same operation.
Note
• When the frequency selected is being broad-
cast in stereo the
STEREO
light.
Section
03
(ST) indicator will
En
21