Replacing The Pump - Honeywell GasAlert Max XT II User Manual

GasAlertMaxXT II
User Manual
3. Depending upon the circumstance, replace either just the
particulate filter or both. Refer to
Moisture Filters.
4. Reattach the pump inlet and replace the screw. Tighten
the screw using 3-4 in-lbs. torque. Do not overtighten.
5. Activate the detector to begin the startup test and the
pump block test. Depending upon the result, one of the
following screens display.
Successful: If the block test is successful, the detector
completes the startup test and enters normal operation.
Unsuccessful: If the block test is unsuccessful, the
detector deactivates. For causes and possible solutions,
refer to Troubleshooting.

Replacing the Pump

To obtain a new pump (XT-RPUMP-K1) and the Pump Replacement
Operator's Manual, refer to Replacement Parts and
60
Particulate Filters and
Accessories.