Configure Your Anker Device; Connect You Router With Anker Device And Connect To The Wireless Web - Anker Compact Wi-Fi Repeater Instruction Manual

Step 4. Configure your Anker device
Logon to the device's configuration page
4.1
Open a web browser on your computer, and type 192.168.100.253 to reach the
device's configuration page. When the log-on dialogue is displayed, enter your
default UserName /Password: admin/admin to logon to the Anker device's
configuration web page.
Configure the device
4.2
The manufacturer default setting is Bridge Mode. Customize the SSID, set
Security Options
Click Finish to apply the settings. Wait 2 minutes to allow a full restart.
Note: If you previously set the Anker device to AP-router mode, then you need to
click Mode settings
restart. Please wait 2 minutes, reconnect to the wireless network, and then logon
to the configuration page again.
Step 5. Connect you router with Anker Device and Connect to the Wireless Web
Connect you router and Anker Device with a network cable, wait 30 seconds to
5.1
allow it restart again.
On your computer, view the list of available wireless networks (typically
5.2
accessible via a Wi-Fi icon located at the corner of your computer's desktop).
Select the newly named network. If the desired network does not appear, please
wait and refresh until the network becomes available.
Connect to your desired network, and input your password when prompted.
5.3
Congratulations! You should now be able to surf the Internet with a strong Wi-Fi
signal from your newly configured 4-in-1 Anker Compact Wi-Fi Repeater.
and your desired PassPhrase.
and choose Bridge Mode. Then the Anker device will
7