Confirm Live Internet Connection; Connect Computer To Your Device; Option 2 Ap-Bridge Mode Installation - Anker Compact Wi-Fi Repeater Instruction Manual

Option 2 AP-Bridge Mode Installation

Step 1. Confirm Live Internet Connection
Step 2. Install your Anker Device
Step 3. Connect Computer to your Device
Step 4. Configure your Anker Device
Step 5. Connect you router with Anker Device and Connect to the Wireless Web
If this is not your first time setting up this device, we recommend that you first reset to
start anew, and then follow the steps below. Please refer to the
reset instructions.
Step 1. Confirm Live Internet Connection
Please verify that your router or modem is working properly and that your existing
devices can connect to the Internet successfully.
Step 2. Install the Device
Select your desired mode
2.1
Please select your desired AP mode and adjust the three-way switch button on
the side panel of your Anker device accordingly.
Select a desired location to plug the Anker device into the wall socket; the LED
2.2
indicators will light after 15 seconds. Please allow a 2-minute start up time.
Step 3. Connect Computer to your Device
Connect your computer to the Anker device
3.1
From your computer, view your available wireless connections (typically
accessible from the corner of your desktop).
Choose the newly available "Anker-AP" network and connect to it. Note that no
3.2
password is needed at this time. Please do not enter any passwords or PIN
codes if prompted, and proceed to connect anyway.
FAQ Question 7 for
6