Anker Compact Wi-Fi Repeater Instruction Manual page 19

default, the network SSID is named "Anker-Repeater". Then configure the
repeater to match the same channel and wireless security settings as your
router.
f. Click
Finish
2. Configure your existing router
2.1 Refer to your router's instruction manual and enter your router's configuration
page.
For your wireless settings, find the WDS configuration setup page.
2.2
2.3 Follow your router's instructions, and when prompted – enter the Anker
repeater's MAC address. If your router can automatically scan for available
wireless networks, select your newly named SSID to allow the router to
automatically fill in the MAC.
2.4 Click Finish
3. Connect to the wireless web
Please refer to Step 5
complete setup.
For WDS-enabled Router setup:
Before Setup: When configured in AP-Router mode, you can enable its WDS function
and allow it to serve as the main WDS base station to which WDS-enabled repeaters
can connect. Please identify the MAC address of your Anker device, printed on the
side of the unit.
Begin standard setup
1.
In the Quick Installation Guide for AP-Bridge, AP-Router and Client
please follow Steps 1-5
a Router.
2. Enable WDS
Logon to the device's configuration page
2.1
Open a web browser on your computer, and type 192.168.100.253 to reach
the device's configuration page. When the log-on dialogue is displayed, enter
your default UserName/Password: admin/admin to logon to the configuration
web page of your repeater.
2.2 Click Wireless setting > Wireless basic settings
channel.
to apply the settings. Wait 2 minutes to allow a full restart.
or Save to apply the settings. Wait 2 minutes to allow a full restart.
of the Quick Installation Guide for Repeater Mode
for AP-Router mode with your Anker device configured as
Mode,
and select your desired
17
to