Anker Compact Wi-Fi Repeater Instruction Manual page 12

PPPoE: Leave Service Name blank and select Get DNS Address Automati-
cally From ISP, if not provided by your ISP
e.
Click Next and keep the
Customize the SSID, i.e. the name of your new wireless network. By default,
the network SSID is named "Anker-AP".
f.
Security Options
Set
Note: For your PassPhrase, i.e. the password to logon to your new wireless
network, this password must contain at least 8 characters and may include
case-sensitive letters and numbers. Save your password in a safe place as a
backup.
g.
Click Finish
Step 5. Connect to the Wireless Web
After the device fully restarts, connect to the wireless web via it.
5.1 On your computer, view the list of available wireless networks (typically
accessible via a Wi-Fi icon located at the corner of your computer's desktop).
Select the newly named network. If the desired network does not appear, please
wait and refresh until the network becomes available.
5.2 Connect to your desired network, and input your password when prompted.
5.3
Follow return to Step 3.2 to configure the IP address settings to your computer's
wireless connection. Please set to DHCP (or dynamic IP) in IPV4 settings.
Congratulations! You should now be able to surf the Internet with a strong Wi-Fi
signal from your newly configured 4-in-1 Anker Compact Wi-Fi Repeater.
Wireless Router Radio
and PassPhrase.
to apply the settings. Wait 2 minutes to allow a full restart.
enabled.
10