Connect Computer To Your Device, And Modify Computer Ip Address; Option 3 Ap-Router Mode Installation - Anker Compact Wi-Fi Repeater Instruction Manual

Option 3 AP-Router Mode Installation

Step 1. Confirm Live Internet Connection
Step 2. Install your Anker Device
Step 3. Connect Computer to your Device, and Modify Computer IP Address
Step 4. Configure your Anker Device
Step 5. Connect to the Wireless Web
If this is not your first time setting up this device, we recommend that you first reset to
start anew, and then follow the steps below. Please refer to the
reset instructions.
Step 1. Confirm Live Internet Connection
Please verify that your router or modem is working properly and that your existing
devices can connect to the Internet successfully.
Step 2. Install the Device
Select your desired mode
2.1
please select your desired
the side panel of your Anker device accordingly.
Select the device location
2.2
Identify the wall socket where you would like to place the Anker device, and make
sure that you have a network cable able to connect to either your existing modem
Do NOT power the device yet. Plug one end of network cable into the Anker
device's network port and the other into the network port of your existing modem.
Plug the Anker device into the wall socket; the LED indicators will light after 15
2.3
seconds. Please allow a 2-minute start up time.
Step 3. Connect Computer to Your Device, and Modify Computer IP Address
3.1
Connect your computer to the Anker device
Connect the computer to your Anker device wirelessly:
a.
From your computer, view your available wireless connections (typically
accessible from the corner of your desktop).
AP mode and adjust the three-way switch button on
FAQ Question 7 for
8