Configure The Device According The Selected Mode - Anker Compact Wi-Fi Repeater Instruction Manual

b.
Choose the newly available "Anker-AP" network and connect to it. Note that no
password is needed at this time. Please do not enter any passwords or PIN
codes if prompted, and proceed to connect anyway.
3.2 You will need to temporarily change your IP address to enter the device
configuration page.
On your computer, please visit your network connections settings and navigate to
the IPv4 setting of your wireless connection. Change the computer's IP address
to 192.168.100.1 and the gateway IP address to 192.168.100.253. Please refer
to FAQ Question 2
Step 4. Configure the Device According the Selected Mode
4.1
Logon to the device's configuration page.
Open a web browser on your computer, and type 192.168.100.253 to reach the
device's configuration page. When the log-on dialogue is displayed, enter your
default UserName/Password: admin/admin to logon to the Anker device's
configuration web page.
4.2 Configure the device
a. Click Mode Settings
Bridge Mode).
Note:
Any change to Mode Settings will cause the device to restart. In this
case, please wait 2 minutes, reconnect to the wireless network, and then logon
to the configuration page again.
b. Click Setup Wizard
Yes
c. Click to allow the setup wizard to automatically detect your connection
type. If you prefer to set this manually, please refer to
details.
d. Your Anker repeater will detect one of the three broadband types: DHCP, Static
IP or PPPoE. Click
information required / provided by your Internet Service Provider (ISP). Then
click Finish
Note the following fields are optional:
DHCP: Leave Account Name blank if not provided by your ISP
Static IP: Leave DNS fields blank if not provided by your ISP
for more detailed instructions.
and confirm it is set to
in the navigation bar on the left.
Yes
to move forward and complete any required
to apply settings.
Router Mode (Default setting is
FAQ Question 5 for
9