Preparing For Use; Brushing Instructions - Philips Sonicare EasyClean HX6511 User Manual

10
English

Preparing for use

Attaching the brush head
1 Align the brush head so the bristles point in the same direction as
the front of the handle (Fig. 2).
2 Firmly press the brush head down onto the metal shaft until it
stops.
Note: There is a small gap between the brush head and the
handle.
Charging the appliance
1 Put the plug in the wall socket.
2 Place the handle on the charger.
3 The battery charge indicator shows the approximate remaining
battery charge.
- Solid green light: 50-100%
- Flashing green light: 5-49%
- Flashing green light and 3 beeps after the brushing cycle: less
than 5% and toothbrush has to be recharged.
Note: To keep the battery fully charged at all times, you may keep
your Philips Sonicare on the charger when not in use. It takes at least
24 hours to fully charge the battery.
Using your Philips Sonicare

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline. (Fig. 3)
Note: Keep the center of the brush in contact with the teeth at all
times.
3 Press the power on/off button to turn on the Philips Sonicare.
4 Apply light pressure to maximize Philips Sonicare's effectiveness
and let the Philips Sonicare toothbrush do the brushing for you. Do
not scrub.