Removing The Cd Mechanism Assembly And The Switch Board - JVC UX-G1 Service Manual

3.1.3 Removing the CD mechanism assembly and the Switch board

(See Fig.8 to 10)
• Prior to performing the following procedure, remove the rear
cover assembly and the main board.
(1) Cut off the four bands setting the wires.
(2) Disconnect the wire from connector on the CD open switch
and CN603, CN606 on the CD mechanism board.
(3) Remove the two screws G on the front panel assembly.
(4) Release the joint d of the CD mechanism assembly.
(5) Remove the five screws H attaching the switch board to the
CD mechanism assembly.
(6) Unsolder the switch board, if necessary.
Open switch connecter
G
Band
Band
Front panel
assembly
Band
Fig.8
CD mechanism
assembly
Joint d
Front panel assembly
Fig.9
H
H
Fig.10
CD mechanism
assembly
CN603
CN606
G
CD mechanism board
CN606
CN603
Open switch connecter
Front panel
assembly
Solder point
Switch board
CD mechanism
assembly
(No.MB412)1-9