Timer Button; Operation Instructions - Midea MPPD-12CRN1-BH9 Service Manual

TIMER BUTTON

Used to initiate the AUTO ON start
time and AUTO OFF stop time program,
in conjuction with the
The timer on/off indicator light
illuminates under the timer on/off
settings.
SWING BUTTON
(Applicable to the models with auto
swing feature only)
Used to initiate the Auto swing feature.
When the operation is ON, press the
SWING button can stop the louver at
the desired angle.
LED DISPLAY
Shows the set temperature in " ℃" or
" ℉" and the Auto-timer settings.
While on DRY and FAN modes, it shows
the room temperature.

2.2 OPERATION INSTRUCTIONS

COOL OPERATION
Press the "MODE" button until the
"COOL" indicator light comes on.
Press the ADJUST buttons "+" or " - "
to select your desired room temperature.
The temperature can be set within a
range of 62℉-88℉/17℃-30℃.
Press the "FAN SPEED" button to
choose the fan speed.
6
& buttons.
(+) (-)
7
8
FOLLOW ME/TEMP SENSING
(OPTIONAL)
NOTE:This feature can be activated
from the remote control ONLY.
The remote control servesas a remote
thermostat allowing for the precise
temperature control at its location.
To activate the Follow Me/Temp
Sensing feature, point the remote
control towards the unit and press
the Follow Me/Temp Sensing button.
The remote display is actual
temperature at its location. The remote
control will send this signal to the air
conditioner every 3 minutes interval
until press the Follow Me/Temp
Sensing button again.If the unit does
not receive the Follow Me/Temp
Sensing signal during any 7 minutes
interval, the unit will beep to indicate
the Follow Me/Temp Sensing mode
has ended
FAN OPERATION
Press the "MODE" button until the
"FAN " indicator light comes on.
Press the "FAN SPEED" button to
choose the fan speed.
The temperaturecannot be adjusted
Do not put the duct to window.
9
