Compliance Information; Fcc Compliance; Declaration Of Conformity - AT&T 3G MICROCELL User Manual

FCC Compliance

United States FCC Compliance
This device has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against such
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy. If not installed and
used in accordance with the instructions,
it may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment OFF and ON, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna,
if applicable.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the cable company or an
experienced radio/television technician
for help.
Any changes or modifications not expressly
approved by Cisco Systems, Inc., could
void the user's authority to operate the
equipment.
The information shown in the FCC Declaration
of Conformity paragraph below is a
requirement of the FCC and is intended to
supply you with information regarding the
FCC approval of this device. The phone
numbers listed are for FCC-related questions
only and not intended for questions regarding
the connection or operation for this device.
Please contact your cable service provider
for any questions you may have regarding
the operation or installation of this device.
22
OCTOBER 24, 2008 DRAFT

Declaration of Conformity

This device complies with Part 15 of FCC
Rules. Operation is subject to the following
two conditions: 1) the device may not cause
harmful interference, and 2) the device must
accept any interference received, including
interference that may cause undesired
operation.
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 770-236-1077
Canada EMI Regulation
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la class B est
conforme à la norme NMB-003 du Canada.
Software and Firmware Use
The software described in this document is
protected by copyright law and furnished to
you under a license agreement. You may only
use or copy this software in accordance with
the terms of your license agreement.
The firmware in this equipment is protected
by copyright law. You may only use the
firmware in the equipment in which it is
provided. Any reproduction or distribution of
this firmware, or any portion of it, without our
express written consent is prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility
for errors or omissions that may appear in this
guide. We reserve the right to change this
guide at any time without notice.
OCTOBER 24, 2008 DRAFT
AT&T 3G MicroCell™
Model: MicroCell
20060628 FCC Standard