Table of Contents
Advertisement
required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output.
The highest SAR value for the device as reported to the FCC
when worn on the body, as described in this us er guide,
is 1.0 W/kg (Body-worn measurements differ
8
among device models, depending upon
available enhancements and FCC requirements.)
While there may be differences between the SAR levels of
various devices and at various positions, they all meet the
government requirement.
The FCC has granted an Equipment Authorization for this device
with all reported SAR levels evaluated as in compliance with the
FCC RF exposure guidelines. SAR information on this device is
on file with the FCC and can be found under the Display Grant
section of h ttp://www.fcc.gov/oet/ea/fccid/ aft er s ear ching on:
FCC ID: SRQ-MF923
SAR compliance for body operation is based on a separation
distance of 10 mm between the unit and the human body. Carry
this device, at least 10 mm away from your body to ensure RF
exposure level compliant or lower to the reported level.
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
54
Regulatory and Safety Information
Caution: Changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate th
equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
・
R
e
r o
e i
n
t or relocate the receiving antenna.
・ r c
n I ease the separation between the equipment and receiver.
・ C onnect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
・ C onsult the dealer or an experienced radio/TV technician for
help.
CTIA Requirements
) a D o not disassemble or open crush, bend or deform,
puncture or shred
Regulatory and Safety Information
55
Advertisement
Table of Contents
