Repair Manual
Removing the Shutter Leafs
Removal
1.
Remove the Shutter Assembly. (See "Removing the Shutter Assembly,"
page 54)
2.
Disassemble the Diaphragm Assembly. (See "Removing the Diaphragm
Assembly," page 64)
3.
Remove the four small phillips bindinghead screws securing the Shutter
Plate to the Driver Plate (Figure 4-21). Lift off the Shutter Plate.
Caution: Take care not to lose the four washers on the shaft of each
screw.
Phillips Bindinghead
Screws (4)
Shutter Plate
Figure 4-21 Shutter Leafs Located Between Shutter Plate and Driver Plate
68
ID-200 Camera
Driver Plate